Identifikasi Plant Purwarupa Heat Exhcanger Tipe Shell dan Tube Model Counter Flow Memanfaatkan Software Matlab

Hairil Budiarto, Faikul Umam

Abstract


Abstract – a heat exchanger is a device that acts as a transfer of heat energy between two fluids or more. There are various ways to improve the effectiveness of heat exchange devices, according to mechanical engineering, by increasing the convection heat transfer coefficient, increasing the surface area of the heat exchanger and increase the temperature difference to reach the specified temperature. The heat transfer can be defined as the transfer of energy from one system to another as a result of the temperature difference, this energy transfer always occurs from a high temperature system to another lower temperature system and will stop after the two systems reach the same temperature, the temperature difference is the main requirement for the transfer of the system. The design of prototype heat exchanger coolermodel counter flow has been made and by utilizing MATLAB software, we have obtained mathematical model of plant order 2, to test the response of plant using simulink in MATLAB, so that the response of the plant at setpoint is still above, improve the performance or response of the plant.

.

Keywords: 


Keywords


Heat exchanger, counter flow, shell and tube cooler, MATLAB

Full Text:

PDF

References


Budiarto. Hairil, “Decrease in Oil Cooler Pressure of Counter flow With Variation Static Twisted Tape Length”. International Journal Of Engineering Research & Technology, Vol.3 – Issue 1. 2014.e-ISSN:2278-0181.

Cengel. Y.A.”Heat transfer A Practical Approach”. McGraw Hill Companies, Amerika, 2003.(references).

Cengel. Y.A.”Fundamental of Thermal-Fluid Sciences”. McGraw Hill Companies, Amerika, 2001.(references).

Ekasari,fatimah,”Fluid Temperatur Control on Heat Exchanger Using Algorithm Model Predictive Control (MPC)”,Journal of Engineering POMITS, Vol.3,No.1,.ISSN:2337-3539,2014.

Hidayat, Rohmat, “Fuzzy Logic Application for Tuning PID Control Parameters in Shell Temperatur and Tube Heat Exchanger Temperatur Setting”. National Conferens, Final Duty departement of Electrical Engineering Diponegoro University Semarang, 2014.

Padhee, Subhransu,”Controller Design For Temperature Control Of Heat Excanger System : Simulation Studies”. WSEAS TRANSACTION on SYSTEM and CONTROL. E-ISSN:2224-2856, Vol.9,2014.

Syahputra, Romadoni,”Temperature Control Simulation on Heat Exchanger Using Adaptive Neuro-Fuzzy”. Journal of Technology, Vol.8, No.2. 2015.

Umam, F., “Water Quality Control for Shrimp Pond Using Adaptive Neuro Fuzzy Inference System: The First Project”.Journal of Physics:Conference Series.2018.




DOI: http://dx.doi.org/10.22441/jtm.v7i2.2674

Refbacks

  • There are currently no refbacks.


Copyright (c) 2018 Jurnal Teknik Mesin

Jurnal Teknik Mesin (JTM)
Program Studi Teknik Mesin, Fakultas Teknik, Universitas Mercu Buana
Jl. Meruya Selatan No. 01, Kembangan, Jakarta Barat 11650, Indonesia
Email: mesin@mercubuana.ac.id
Telp.: 021-5840815/ 021-5840816 (Hunting)
Fax.: 021-5871335

JTM is indexed by the following abstracting and indexing services:

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

View My Stats